Đang chuẩn bị liên kết để tải về tài liệu:
Lab 6.2.1 Verifying Default on Switch Configuration

Không đóng trình duyệt đến khi xuất hiện nút TẢI XUỐNG Tải xuống

Cable a network similar to the one in the diagram. The configuration output used in this lab is produced from a 2950 series switch. Any other switch used in this lab may produce different output. The following steps are to be executed on each switch, unless instructed otherwise. Instructions are also provided for the 1900 Series switch, which initially displays a User Interface Menu. Select the “Command Line” option from the menu to perform the steps for this lab. Start a HyperTerminal session. Note: Go to the erase and reload instructions at the end of this lab. Perform those steps on all switches in this lab assignment. | Cisco SrsTEMS Lab 6.2.1 Verifying Default Switch Configuration Straight-through cable ---------------------------- Serial cable S Console Rollover . Crossover cable . Objective Investigate the default configuration of a 2900 series switch. Background Preparation Cable a network similar to the one in the diagram. The configuration output used in this lab is produced from a 2950 series switch. Any other switch used in this lab may produce different output. The following steps are to be executed on each switch unless instructed otherwise. Instructions are also provided for the 1900 Series switch which initially displays a User Interface Menu. Select the Command Line option from the menu to perform the steps for this lab. Start a HyperTerminal session. Note Go to the erase and reload instructions at the end of this lab. Perform those steps on all switches in this lab assignment before continuing. General Configuration Tips Using the question mark and arrow keys help to enter commands. Each command mode restricts the set of available commands. If there is difficulty entering a command check the prompt and then enter the question mark for a list of available commands. The problem might be a wrong command mode or using the wrong syntax. To disable a feature enter the keyword no before the command for example no ip address. Save the configuration changes to NVRAM so that the changes are not lost if there is a system reload or power outage. 1 - 8 CCNA 3 Switching Basics and Intermediate Routing v 3.0 - Lab 6.2.1 Copyright 2003 Cisco Systems Inc. Switch Command Modes Command Mode Access Method Switch Prompt Displayed Exit Method User EXEC Log in Switch Use the logout command. Privileged EXEC From user EXEC mode enter the enable command. Switch To exit to user EXEC mode use the disable exit or logout command. Global configuration From the privileged EXEC mode enter the configure terminal command. Switch config To exit to privileged EXEC mode use the exit or end command or .