Đang chuẩn bị liên kết để tải về tài liệu:
Lab 6.2.7a Managing Switch Operating System Files

Không đóng trình duyệt đến khi xuất hiện nút TẢI XUỐNG Tải xuống

Tham khảo tài liệu 'lab 6.2.7a managing switch operating system files', công nghệ thông tin, quản trị mạng phục vụ nhu cầu học tập, nghiên cứu và làm việc hiệu quả | Cisco SrsTEMS Lab 6.2.7a Managing Switch Operating System Files Switch Switch Enable Secret Enable VTY VLAN 1 IP Default Subnet Mask Designation Name Password and Console Address Gateway IP Passwords Address Switch 1 AL Switch class cisco 192.168.1.2 192.168.1.1 255.255.255.0 Straight-through cable ------------------ Serial cable Console Rollover . Crossover cable _ Objective Create and verify a basic switch configuration. Backup the switch IOS to a TFTP server and then restore it. Background Preparation Cable a network similar to the one in the diagram. The configuration output used in this lab is produced from a 2950 series switch. Any other switch used may produce different output. The following steps are to be executed on each switch unless specifically instructed otherwise. Instructions are also provided for the 1900 Series switch which initially displays a User Interface Menu. Select the Command Line option from the menu to perform the steps for this lab. Start a HyperTerminal session. Note Go to the erase and reload instructions at the end of this lab. Perform those steps on all switches in this lab assignment before continuing. Step 1 Configure the switch Configure the hostname access and command mode passwords as well as the management LAN settings. These values are shown in the chart. If problems occur while performing this configuration refer to the Basic Switch Configuration lab. Step 2 Configure the hosts attached to the switch Configure the host to use the same subnet for the address mask and default gateway as on the switch. This host will act as the TFTP server in this lab. Be sure to take note of the IP address assigned. 1 - 7 CCNA 3 Switching Basics and Intermediate Routing v 3.0 - Lab 6.2.7a Copyright 2003 Cisco Systems Inc. Step 3 Verify connectivity a. To verify that the host and switch are correctly configured ping the switch IP address from the host. b. Was the ping successful .