Đang chuẩn bị liên kết để tải về tài liệu:
1 - 4 CCNA 3: Switching Basics and Intermediate Routing v 3.0 - Lab 7.2.6 Copyright  2003, Cisco Systems, Inc. Lab 7.2.6 Spanning Tree Recalculation

Cable a network similar to one of the diagram. The configuration output used in this lab is produced from a 2950 series switch. Any other switch used may produce different output. The following steps are to be executed on each switch unless specifically instructed otherwise. Start a HyperTerminal session. | Cisco SrsTEMS Lab 7.2.6 Spanning Tree Recalculation FA 04 FA 04 Switch Designation Switch Name Enabe Secret Password Enable VTY and Console Passwords VLAN 1 IP Address Default Gateway IP Address Subnet Mask Switch 1 Switch_A class cisco 192.168.1.2 192.168.1.1 255 255.255.0 Switch 2 SwitchB class cisco 192.168.1.3 192.168.1.1 255.255.255.0 Straight-through cable Serial cable Console Rollover Crossover cable Objective Create a basic switch configuration and verify it. Observe the behavior of spanning-tree algorithm in presence of switched network topology changes. Background Preparation Cable a network similar to one of the diagram. The configuration output used in this lab is produced from a 2950 series switch. Any other switch used may produce different output. The following steps are to be executed on each switch unless specifically instructed otherwise. Start a HyperTerminal session. Step 1 Configure the switches Configure the hostname access and command mode passwords as well as the management LAN settings. These values are shown in the chart. If problems occur while performing this configuration refer to the Basic Switch Configuration lab. Step 2 Configure the hosts attached to the switches Configure the host to use the same IP subnet for the address mask and default gateway as on the switch. Step 3 Verify connectivity a. To verify that the hosts and switches are correctly configured ping the switches from the hosts. b. Were the pings successful __ c. If the answer is no troubleshoot the hosts and switches configurations. 1 - 4 CCNA 3 Switching Basics and Intermediate Routing v 3.0 - Lab 7.2.6 Copyright 2003 Cisco Systems Inc. Step 4 Look at the show interface information a. On both switches type the command show interface vlani at the privileged EXEC prompt as follows Switch_A show interface vlan 1 b. What is the MAC address of this switch Switch_B