Đang chuẩn bị liên kết để tải về tài liệu:
Catalyst 2900 TFTP Configuration Files

You have just taken a job at a company that uses Catalyst 2900 Ethernet switches in their IDFs. You want to save a copy of the configuration file from your Catalyst 2900 switch to a TFTP server for safekeeping. | Lab 3.3.7.2 Catalyst 2900 TFTP Configuration Files Objective Copy your current configuration to a TFTP server. Scenario You have just taken a job at a company that uses Catalyst 2900 Ethernet switches in their IDFs. You want to save a copy of the configuration file from your Catalyst 2900 switch to a TFTP server for safekeeping. Lab Tasks 1. First configure your 2900 switch to the diagram above. You can skip this step if you already have the Lab 3.2.3 2900 initial setup configured. Switch enable Switch Set the switch name. Switch config terminal Switch config host ALSwitch ALSwitch config ALSwitch config enable password class ALSwitch config line con 0 ALSwitch config-line password cisco ALSwitch config-line login ALSwitch config-line line vty 0 15 ALSwitch config-line password cisco ALSwitch config-line login ALSwitch config interface vlan 1 ALSwitch config-if ip address 10.1.1.251 255.255.255.0 Configure the IP address of your workstation to 10.1.1.10 24. Make sure you have the Cisco TFTP server loaded on this workstation. 2. You will use the copy command to copy the configuration from the switch to the TFTP server. Type copy to see what other options you have. What other locations can you copy the configuration file to 3. Now use the copy running-config tftp command to move the configuration to your TFTP server. ALSwitch copy running-config tftp Address or name of remote host 10.1.1.10 Destination filename running-config ALSwitch Use your switch name 1165 bytes copied in 4.173 secs 291 bytes sec ALSwitch 4. Check the configuration file that was saved to your tftp server. Is the copy a full version of the configuration or just the non-default commands