Đang chuẩn bị liên kết để tải về tài liệu:
Supporting Novell on Cisco Routers Lab Scenario

Không đóng trình duyệt đến khi xuất hiện nút TẢI XUỐNG Tải xuống

You will need the following equipment: l Two Cisco routers ¡ One needs to have at least two Ethernet ports. ¡ One needs at least one Ethernet port (though two ports would be preferable). l One Ethernet hub l One Novell file server l One Windows workstation with an available serial port and Windows HyperTerminal software l Two cat 5 patch cables and one cat 5 crossover cable (assuming the routers have RJ45 interfaces. If not, you'll need a crossover cable with ends appropriate for connecting the routers to one another, and patch cables to connect the server and one router to the hub.) l A Cisco RJ45-to-DB9 adapter and. | CertificationZone Page 1 of 5 Date of Issue 02-01-2001 Supporting Novell on Cisco Routers Lab Scenario by Katherine Tallis Setting up the Lab Performing the Lab Testing Some IPX Commands Setting up the Lab You will need the following equipment Two Cisco routers o One needs to have at least two Ethernet ports. o One needs at least one Ethernet port though two ports would be preferable . One Ethernet hub One Novell file server One Windows workstation with an available serial port and Windows HyperTerminal software Two cat 5 patch cables and one cat 5 crossover cable assuming the routers have RJ45 interfaces. If not you ll need a crossover cable with ends appropriate for connecting the routers to one another and patch cables to connect the server and one router to the hub. A Cisco RJ45-to-DB9 adapter and console cable which should have shipped with each of the routers to attach the serial port of the workstation to the console port of each of the routers Assemble the equipment as shown Lab Configuration IPX network 000 aa IPX Network bbbbb IPX Network ceceo Ethernet 0 IP 10.1.1.1 Ethernet 1 IP 10.1.2.1 Elhernol 1 IP 10.1.2.2 j Router A Ethernet 0 . IP 10.1.3.1 F if the router has a Route riSe nJ e them el port B . f Console Cable NetWare Server Network number aaaaa INA-IPX-I.S2-01 Cornpul er Connect the server and RouterA to the hub with patch cables. Use a crossover cable to connect the routers to one another. http www.certificationzone.com studyguides. Issue 30 IssueDate 02-01-2001 CP 11 06 01 CertificationZone Page 2 of 5 Performing the Lab With the workstation s serial port plugged into the console port on RouterA bring up the HyperTerminal software press the ENTER key several times and make sure you see the router s prompt Router-name If you are prompted for a user password prior to getting into the router you will have to find out what it and the enable password are before you can complete the exercise. Go into enable mode on the router Router-name enable If you