Đang chuẩn bị liên kết để tải về tài liệu:
Multiprotocol Skills LAB

1. Setup routers as shown in the diagram below: 2. Using a CS-500 or 2509-2511 connect an asynchronous serial port to the console port on each router. Configure a ip host list for a reverse telnet session into each router. | Multiprotocol Skills LAB R4 R5 R3 Lab 1. Connect Terminal Server 1 hour 1. Setup routers as shown in the diagram below 2. Using a CS-500 or 2509-2511 connect an asynchronous serial port to the console port on each router. Configure a ip host list for a reverse telnet session into each router. Lab 2. IP 6 hours Configure the network using network 172.16.x.x Use an 8 bit subnet mask unless otherwise specified At the end of each exercise verify connectivity between all ports All ip routes appearing in all routers Ping from any interface to any other interface Lab 2a 1. Connect R1 R2 and R3 over Frame Relay X.25 choose . Configure R3 using subinterfaces. Configure R1 without using subinterfaces and using map commands. Configure R2 without using subinterfaces or map commands. 2. Configure OSPF with the cloud in area 0. Configure R4 R5 and R3-R4 serial to be in area 1. 3. Configure two loopbacks on R1 using subnets that will contain at most 14 hosts ip addresses. Configure two loopbacks on R2 using subnets that will contain at most 62 hosts. Summarize the two loopback interfaces on R1 and R2 such that R3 only sees one route from each. Lab 2b 1. Remove OSPF configurations from R4 R5 and the serial connection between R3 and R4. Configure EIGRP on R4 R5 and on the serial connection between R3 and R4. Redistribute OSPF and EIGRP on R3. 2. Repeat step 1 using IGRP instead of EIGRP. Lab 2c 1. Remove IGRP from R3 and the serial link between R3 and R4. Create a BGP autonomous network between these routers. Redistribute and aggregate all routes. Lab 2d 1. Filter such that only R5 can ping the loopbacks on R2 but not the ethernet. The route for the ethernet should still be visible 2. Filter on R4 such that R1 R2 and R3 only see the routes from the token-ring interface on R5. Lab 2e 1. Remove filters from R4. 2. Configure R4 such that it advertises a default network to R5. R5 should be able to ping all interfaces. Lab III. Appletalk 1 hour At the end of each exercise verify .