"nuclear engineering and technology" trang 9 - tải miễn phí từ tailieuXANH
RCD success criteria estimation based on allowable coping time

RCD success criteria estimation based on allowable coping time
8    160    0
Influence of design modification of control rod assembly for Prototype Generation IV Sodium-cooled Fast Reactor on drop performance

Influence of design modification of control rod assembly for Prototype Generation IV Sodium-cooled Fast Reactor on drop performance
8    47    0
Impact of thermal and chemical treatment on the mechanical properties of E110 and E110G cladding tubes

Impact of thermal and chemical treatment on the mechanical properties of E110 and E110G cladding tubes
8    71    0
Comparison of knife-edge and multi-slit camera for proton beam range verification by Monte Carlo simulation

Comparison of knife-edge and multi-slit camera for proton beam range verification by Monte Carlo simulation
6    54    0
Solidification of high level waste using magnesium potassium phosphate compound

Solidification of high level waste using magnesium potassium phosphate compound
6    64    0
Sorption characteristics of iodide on chalcocite and mackinawite under pH variations in alkaline conditions

Sorption characteristics of iodide on chalcocite and mackinawite under pH variations in alkaline conditions
6    37    0
A new approach to determine batch size for the batch method in the Monte Carlo Eigenvalue calculation

A new approach to determine batch size for the batch method in the Monte Carlo Eigenvalue calculation
9    71    0
Radiation protective qualities of some selected lead and bismuth salts in the wide gamma energy region

Radiation protective qualities of some selected lead and bismuth salts in the wide gamma energy region
7    55    0
Mathematical approach for optimization of magnetohydrodynamic circulation system

Mathematical approach for optimization of magnetohydrodynamic circulation system
11    44    0
Evaluation of effectiveness of fault-tolerant techniques in a digital instrumentation and control system with a fault injection experiment

Evaluation of effectiveness of fault-tolerant techniques in a digital instrumentation and control system with a fault injection experiment
10    51    0
Performance analysis of the passive safety features of iPOWER under Fukushima-like accident conditions

Performance analysis of the passive safety features of iPOWER under Fukushima-like accident conditions
7    55    0
Low-frequency modes in the fluid-structure interaction of a U-tube model for the steam generator in a PWR

Low-frequency modes in the fluid-structure interaction of a U-tube model for the steam generator in a PWR
9    57    0
Radiation damage to Ni-based alloys in Wolsong CANDU reactor environments

Radiation damage to Ni-based alloys in Wolsong CANDU reactor environments
7    39    0
Development of multi-cell flows in the three-layered configuration of oxide layer and their influence on the reactor vessel heating

Development of multi-cell flows in the three-layered configuration of oxide layer and their influence on the reactor vessel heating
12    61    0
Evaluation of gamma-ray and neutron attenuation properties of some polymers

Evaluation of gamma-ray and neutron attenuation properties of some polymers
7    79    0
Improvement of the MARS subcooled boiling model for a vertical upward flow

Improvement of the MARS subcooled boiling model for a vertical upward flow
10    50    0
Development status of microcell UO2 pellet for accident-tolerant fue

Development status of microcell UO2 pellet for accident-tolerant fue
6    45    0
Correlation between rare earth elements in the chemical interactions of HT9 cladding

Correlation between rare earth elements in the chemical interactions of HT9 cladding
8    63    0
Numerical prediction of a flashing flow of saturated water at high pressure

Numerical prediction of a flashing flow of saturated water at high pressure
11    167    0
Theoretical models of threshold stress intensity factor and critical hydride length for delayed hydride cracking considering thermal stresses

Theoretical models of threshold stress intensity factor and critical hydride length for delayed hydride cracking considering thermal stresses
10    87    0
Đã phát hiện trình chặn quảng cáo AdBlock
Trang web này phụ thuộc vào doanh thu từ số lần hiển thị quảng cáo để tồn tại. Vui lòng tắt trình chặn quảng cáo của bạn hoặc tạm dừng tính năng chặn quảng cáo cho trang web này.