Đang chuẩn bị liên kết để tải về tài liệu:
Nghệ thuật xếp hình Nhật Bản:humpty_dumpty_2

Nghệ thuật xếp hình: humpty_dumpty_2. Tài liệu rất có ích, nó giúp bạn nâng cao kỹ năng gấp tất cả mọi thứ bằng giấy. Bạn có thể gấp thành thạo những gì bạn thích cho riêng mình và cho bạn bè bạn. | Humpty Dumpty by Kalei Anne Lundberg copyright 2001 Nine inch paper will result in a model about three and a half inches tall. The diagrams are offered for personal use for any other use please contact me for permission at models@kalei.com. is Humpty Dumpty sat on a wall t55 55 Humpty Dumpty had a great fall iS All the king s horses and all the king s men S5 55 Cannot set Humpty Dumpty up again. 5S 55 Mother Goose 5S 1913 edition t55 1. Collapse into a colored 2. Squash fold. Repeat on 3. Valley fold top flap to the preliminary fold. Turn model the back side. right. Repeat on the back so free points are on the side. 4. Squash fold. Repeat on back side. 5. Petal fold. Repeat on the back side. 6. Valley fold the small point downward. Repeat on the back side. Humpty Dumpty page 1 of 5 http www.kalei.com 7. Valley fold the top two left hand flaps to the right and the back two right hand flaps to the left. Minor Miracle 8. Repeat steps 5 and 6. 9. Lily Frog base 10. Valley fold Minor Miracle one upward. Repeat on flap. the back side. 11. Minor Miracle one flap. 12. Repeat step 10. 13. Valley fold and unfold to set creases. 14. Note on forming the wall section The idea is to transform this face of the frog base into a stretched bird form by sinking the two sides along the precreases made in step 13 while forming the addition inside reverses needed along the center line during the collapse. The next series of diagrams are enlarged to show as much detail as possible. Humpty Dumpty page 2 of 5 http www.kalei.com 15. This diagram shows the face extended to detail the crease pattern. Note that the three lines marked with white circles will be the new creases that form the inside 16. 3D representation of the collapse in progress. reverse folds 17. Stretched Bird Form Valley fold and unfold. 18. Open the model and outside reverse fold along the crease just made to where it intersects with the folds marked by the white circles. Note the model should be 3D after this maneuver. .