Đang chuẩn bị liên kết để tải về tài liệu:
Nghệ thuật xếp hình Nhật Bản:jonathon_2

Nghệ thuật xếp hình: jonathon_2. Tài liệu rất có ích, nó giúp bạn nâng cao kỹ năng gấp tất cả mọi thứ bằng giấy. Bạn có thể gấp thành thạo những gì bạn thích cho riêng mình và cho bạn bè bạn. | Jonathon Jump Ant By Perry Bailey c 1999 This model is for my son Jonathon who I have not heard from in many years but who remains in my heart and in my thoughts. 1 To begin precrease the paper as shown in the diagram. White side up if using Origami Paper. Please note that you don t have to do any precreasing it just makes it easier the first time around. Cupboard fold the sides to the center of the model. Mountain fold the top layer of the left side of the model from the half way point up to the center of the model one quarter of the length from the top. In doing this you will bring the upper right inside corner of the paper down to the left of the model one quarter of the way up from the bottom. Go ahead and for convenience fold the top quarter of the right side in a valley fold just so you can see that flat it matches the next diagram. Now while bringing the left side of the model back over to the left repeat step 3 on the right side of the model. Valley fold up the top left flap bring the raw edge to the top of the model. Valley fold all the upper layers to the right. Valley fold the flap up to the top of the model. Mountain fold the bottom 2 Layers of the model under to the left. Perform an Inside reverse fold on both sides flaps . This will give you three points and a good start on half of the legs. Valley fold top layer down so the raw edge is even with the bottom edge of the flap then unfold. Inside reverse fold the flap along the lines of the crease made in the previous step. Valley fold down the flap created by the reverse fold. Repeat step 10 through 12 on the other side of the model. Reverse fold the flap sticking up on each side into the model. At this point the view looking down at the model from above should slightly resemble This in a vague sort of way. Perform an open sink on the center flap making it even with the side flaps you will need to open up the top of the model to do this. Unless you are a masochist and then feel free to make it as hard .