Đang chuẩn bị liên kết để tải về tài liệu:
Nghệ thuật xếp hình Nhật Bản:dragonfly 2

Nghệ thuật xếp hình: dragonfly 2. Tài liệu rất có ích, nó giúp bạn nâng cao kỹ năng gấp tất cả mọi thứ bằng giấy. Bạn có thể gấp thành thạo những gì bạn thích cho riêng mình và cho bạn bè bạn. | Dragonfly version 2 Copyright 1998-2000 Stephen Hecht. All Rights Reserved This model s design borrows from Robert Lang s dragonfly in The Complete Book of Origami Dover 1988 . For your first attempt begin with a 3x7 rectangle considerably larger than a dollar bill. A dollar bill makes a model 45mm long with a 63mm wingspan and requires tweezers. 3. Rabbit-ear. Repeat on left. 1. Begin green side up. Valley-crease the long way mountain-crease the short way. 2. Bisect the middle 4 right angles with valley-creases. 6. Crease bisectors. 4. Fold and unfold. Turn over and rotate 1 4 turn. 5. Crease bisectors stopping where shown. Then swing flaps around. 7. Collapse. A layer swings out from behind at the 4 tiny arrows and the long flaps stand straight up. 8. Swing the left half of the central diamond under the right half the standing flaps fall to the left. No new creases. Rotate. 9. Reverse-fold on existing creases. Dragonfly v2 continued Copyright 1998-2000 Stephen Hecht. All Rights Reserved 10. Flip one layer down incorporating a reverse-fold. Unfold. Repeat on left and twice behind. 11. Lift bottom point opening paper completely. 12. The central diamond-shape sticks up. The indicated points are concave. Push them up from behind to invert them. 13. Pinch together all the edges in the range A swinging them under. Meanwhile divide the central diamond. Only the tiny valley fold is a new crease. 14. Flip one flap to the right. Repeat 13-14 on the left. Turn over. 15. Reverse-fold in-and-out. Repeat on left. 16. Reverse-fold 1 layer over 2. Crease only the front half sharply. See next diagram for positioning. 17. Flip the rectangular section behind and upwards. This is a reverse-fold. Do not crease sharply. 18. Reverse-fold 1 layer over 2. Crease only the rear half sharply. Note bisected angle. Dragonfly v2 continued Copyright 1998-2000 Stephen Hecht. All Rights Reserved 19. Pull single-ply black triangle to the left. This will drag the single-ply rectanglular piece of .