Đang chuẩn bị liên kết để tải về tài liệu:
How To Build Your Own Computer phần 4

Nhưng, hãy nhớ rằng, thường xuyên, nhà sản xuất PC giảm giá bằng cách sử dụng các bộ phận chất lượng thấp hơn. Ngoài ra, nếu bạn không biết bạn đang ass từ máy PC, bạn có thể được một số người bán hàng sẽ chọn lên trên đó và thực sự | STEP 12 Install Floppy Drive 1. Choose which drive bay you want to install the drive to and remove the face plate off of that bay. Save the face plate for future use. Pick a bay that will fit the drive. If you have to install a 3.5 drive in a 5.25 bay you ll have to use a special front panel to adapt it. This panel usually comes with a new floppy drive. 2. Now slide the drive into the bay from the front. If your particular case has a drive rack then you may need to remove the rack from the system and then screw the drive into the rack separately from the actual case. Otherwise screw the drive into the case itself. Before doing so make sure the front of the drive is flush with the front of the PC. 3. If you are using brackets to hold the drive in place secure them now. You may need to temporarily disconnect the cables. Once in tighten the drive in place. Double-check the connections also checking the connections for other drives to make sure you didn t bump one out of place. 4. Now the floppy disk drive should be installed properly. 5. OPTIONAL If you are installing a 3.5 internal ZIP drive you install it the same way and into the second floppy drive bay of your case. This e-book is copyright to Glyn Williams. If you have purchased this book from elsewhere please e- mail glyn@uk-interactive.co.uk for a reward STEP 13 Configure the Hard Drive CD-ROM It is much easier to configure these drives before you actually install them in the case. If you install them first having enough room to actually set the jumpers can be a problem. Before doing this you must decide what type of drives and how many you want in your system. Then you will need to decide how to configure them to make them all work together. Here is some data to help you out Your motherboard has two IDE channels each supporting two devices. So if you want two hard drives for example you should have one be the master and the other be the slave . Have your main hard drive the one with your operating system be .