Đang chuẩn bị liên kết để tải về tài liệu:
Dimension TM 3100 Manual Version 4.43B phần 9

Kỹ thuật điện giai đoạn phát hiện tiếp tục . Lưu ý: Đối với các phiên bản phần mềm 4,23 và thấp hơn thiết lập Interleave quét nâng và chuyển đổi chế độ Interleave để Enable trong bảng điều khiển Interleave. 8. Đặt dòng kênh Quét 2 đến Interleave để hiển thị các dữ liệu xen kẽ. | Electric Techniques Phase Detection continued. 0 For software versions 4.23 and lower set . nnaind switch . niiii to Iii8ii nfllthe. Interleave Controls panel. 8. Set the Channel . to .to display interleave data. For software versions 4.23 and lower there are no separate Analog 2 setting in the .i. anel. Set Analog 2 in the 6IÌTTTK.panel to. 9. In thel .panel set. the desired voltage. 0 Applying a voltage during the main line can make Tapping Mode operation difficult. 10. Optimize the iiiiiiiiiiii-inn-r lFor high-resolution set the IIIIII iniiiii-iI in-ras small as possible without crashing the tip into the surface. There are two ways to determine if the tip is touching the surface If the tip crashes into the surface it typically creates bright or dark specks or streaks in the image. Also if the IIIIIIIIIII1 I - - s set extremely low the tip may continuously tap on the surface during the LiftMode scan. Toggle between the iiiiiiiiiiiiiand niiH Iiiiiiiiiiiiiiiii for the phase image. If the two images appear similar this indicates the tip is continuously tapping on the surface during the LiftMode scan. Increase the iiiiiiiiiiii-il in-nintil the IIIIIIII Hirn kcan image changes indicating that the tip is oscillating above the surface and not continuously tapping. 11. Adjust the sample or tip voltage to confirm that contrast is due to electrical force gradients. 16-24 Dimension 3100 Manual Rev. B Electric Techniques Phase Detection continued. 0 For software versions 4.23 and lower set . nnaind switch . niiii to Iii8ii nfllthe. Interleave Controls panel. 8. Set the Channel . to .to display interleave data. For software versions 4.23 and lower there are no separate Analog 2 setting in the .i. anel. Set Analog 2 in the 6IÌTTTK.panel to. 9. In thel .panel set. the desired voltage. 0 Applying a voltage during the main line can make Tapping Mode operation difficult. 10. Optimize the iiiiiiiiiiii-inn-r lFor high-resolution set the IIIIII iniiiii-iI in-ras small as possible .